How do I setup my Linksys WAG120N router?

Access to the user interface

1. Put router into operation.
2. Connect the device via Wi-Fi* or a network cable with the router.
3. Start web browser.
4. Insert IP address in the address bar and confirm with ‘Enter’ button.
5. Enter username and password in the open user interface and confirm again.

How do I connect my ADSL2+ modem router?

Connect the Modem-Router’s power cord into the back of the Modem-Router. Connect a telephone cable from the wall into the back of the Modem-Router. Find your new networking cable (it came in the box with your Modem-Router) and connect it to one of the LAN ports on the back of the Modem-Router.

How do I reset my WAG120N?

There are two (2) ways to reset the Linksys WAG120N to factory defaults. Either press and hold the Reset button for approximately 30 seconds, or restore to factory defaults from the Administration > Factory Defaults screen of the web-based setup page.

Is Linksys a modem or router?

The Linksys Smart Wi-Fi Modem Router, XAC1200 can have a wireless network speed of up to 867 Mbps when matched with an 802.11ac adapter.

How do I configure my ADSL modem as a wireless router?

Power on your router and computer first and then modem.

1. Log into the router’s web-based management page.
2. Configure WAN Connection Type.
3. Enter your PPPoE username and password which are provided by your ISP.
4. Click Save to save your settings, then the router will connect to Internet after a while.

How to mount a wireless ADSL2 Modem Router?

Chapter 1Product Overview Wireless ADSL2+ Modem Router2 Follow these instructions: 1. Determine where you want to mount the device. Make sure that the wall you use is smooth, flat, dry, and sturdy. Also make sure the location is within reach of an electrical outlet. 2. Drill two holes into the wall.

What are the LEDs on a wireless modem router?

Front Panel Power (WAG120N: Green/Amber; WAG160N v2 and WAG320N: Green/Red) The Power LED is continuously lit green while the device is powered on. The LED is lit amber (WAG120N) or red (WAG160N  v2 and WAG320N) if a POST (Power On Self Test) failure or device malfunction occurs.

What can I do with a wireless modem router?

Thank you for choosing the Wireless ADSL2+ Modem Router. This device lets you access the Internet via a wireless connection or through one of its four switched ports. You can also use it to share resources such as computers, printers and files.

How does ADSL work on a modem router?

DSL (Green) The DSL LED lights up whenever there is a successful DSL connection. The LED flashes green while the Modem Router is establishing the ADSL connection. Internet (Green/Red) The Internet LED lights up green and stays on when a connection is made through the Internet port.