Popular articles

What kind of transmission does the Honda K24A4 have?

What kind of transmission does the Honda K24A4 have?

The motor also comes with a 5 speed transmission instead of the 6 speed and has no LSD. If using a K24a4 block the pistons will need to be swapped with aftermarket or a1, a2 pistons to avoid valve to piston contact. This engine is found in the (06-07) Honda Accord and (07-08) Honda Element.

What kind of pistons are in a Honda K24A4 block?

K24a4 pistons and rods were removed, nothing else internaly. taking a closer look. k24a4 block almost complete with the k24a2 pistons and rods inserted. What is needed to complete the bottom section of the block is shown here. completing the timing chain requirements are listed here.

Is the water pump on the accord K24A4?

K24a4 (accord) block was dissasembled, only thing that was kept on it was the water pump since that has to remain with the block since the block has no oil cooler assembly (maybe that can be adapted later on) i chose not to include it for simplicity. K24a4 pistons and rods were removed, nothing else internaly.

How much horsepower does a Honda k20a4 engine have?

This engine shares the same downfalls with the K24A4 engines as the pistons will contact the K20 cylinder head. This engine is found in the (07-09) Honda CR-V. It has the common 9.7:1 compression and is rated at 166 hp @ 5800 rpm and 161 lb·ft @ 4200 rpm with a red kline of 6500 rpm.

How many horsepower does a 4piston K24 engine have?

But with the lightweight reciprocating pieces, 4Piston prefers to pull some mass out of this rotating package and have milled and drilled their current crank down to 33 pounds. They have experience with a customer engine that is currently supercharged at 725 hp with one of these cranks and it is living just fine.

How big is the bore on a K24 engine?

But the price for spinning engines hard is steep both monetarily and in a commitment to building the best. Starting with a production K24 block, 4Piston installed a set of LA Sleeve ductile iron liners to push the bore out to 90mm (3.54-inch) over the stock 87mm (3.42-inch).