Popular articles

How do I choose a DHCP server?

by Ellenor Mcfarland

How do I choose a DHCP server?

Procedure

  1. Assign IP addresses to interfaces on the switches. (Details not shown.)
  2. Configure Switch B and Switch C as DHCP servers. (Details not shown.)
  3. Configure the DHCP relay agent on Switch A: # Enable DHCP. system-view [SwitchA] dhcp enable. # Enable the DHCP relay agent on VLAN-interface 2.

How do I find my DHCP scope?

Adding DHCP Servers to be Monitored

  1. Click the Tools tab.
  2. Choose the DHCP Scope Monitor available under the Address Monitoring category.
  3. Specify the Name or the IP Address of the DHCP Server.
  4. Specify the SNMP Read Community of the DHCP Server.
  5. Click Get DHCP Scope Details.

Which is a message of DHCP?

One or more DHCP servers will respond with a DHCPOFFER message that contains an available network address and other configuration parameters. When the client needs an IP address, it sends a DHCPREQUEST to one or more servers.

How to set up DHCP in Windows Server 2008?

This guide assumes that you have Server 2008 up and running on a machine–if you don’t, you should check out our guide on how to install it. You should also have set a static IP address on the server before continuing. To get started, fire up the Server Manager, right click on roles, and then select add roles.

How to set up DHCP in Windows Server R2?

IT: How to Set Up DHCP in Windows Server 2008 R2. 1 Give your scope a name. 2 Enter the first address that you want available to clients to use. 3 Enter the last address that you want available to clients to use. 4 Enter the subnet mask (usually 255.255.255.0) 5 Enter the IP address of your default gateway (usually your router IP at .1)

Where do I put the IP address for DHCP?

Put in the IP address of your DNS Server, which in this case is the same machine–but be careful not to put the loopback address (127.0.0.1) as this will be the address your clients will go to for name resolution. Click next again to skip the WINS setup, this will bring you to creating a DHCP Scope, where you can click the Add button.

How long does it take to set up a DHCP server?

A DHCP scope defines one or more ranges of IP addresses from which an IP address may assigned to a client and the duration of the IP address lease (6 days for wired clients and 8 hours for wireless clients). This may either be configured now, or at a later point in the configuration process.