Can you connect utility sink to washer drain?

Using your utility sink’s drain line measurement, measure up from the ground and make a mark on your washer’s drain line. This is where you will place the new Y-fitting that will separate the washer’s drain from the utility sink’s drain in the next step.

What size is a utility sink drain?

Most sinks in a house will only require a 1.5″ drain when installing new piping. However the drain size for a laundry sink needs to be 2″ in diameter. A laundry sink is sometimes referred to as a utility sink is often located in the same room as the washer and dryer. A laundry sink needs to be 2″ instead of 1.5″.

Can 2 sinks share the same drain?

In most cases, you can easily adapt the supply and drain pipes to accommodate two sinks, using tee fittings, special valves, extension pipes and hoses. You may have to vent each sink separately, though, depending on your local plumbing codes.

Is it hard to add sink to laundry room?

As long as the laundry room has enough space for a sink and a water supply and proper drainage are accessible, there is no reason you cannot install a utility sink by yourself.

Can you drain a sink into a floor drain?

There is no problem with a sink, or even a shower, draining directly into a floor drain. If you seal off the opening, you will have a problem. The floor drain has a trap, so you will be double trapping the sink.

Does a double sink need two P traps?

A double bathroom sink installation rarely requires more than one P-trap. The usual practice is to connect the two sinks to a tee and then feed the tee into a single P-trap, which then connects to the drain. The pipes you use to connect the sink to the P-trap are the same type the P-trap is made from.

How do you remove a utility sink permanently?

Crawl under the sink with a headlamp and locate the screws and brackets holding the sink to the countertop. Loosen the screws with a Phillips screwdriver until the brackets come loose. Remove the brackets and pull out the sink.

Where does utility sink drain?

Set the utility sink in place against the wall where the rough plumbing drain is installed; plumbers must connect drains to the main sewer line and typically leave a PVC or metal pipe extending from the wall, adjacent to the water supply lines.

Does double kitchen sink require two traps?

A double kitchen sink, on the other hand, is the double sink you find in many kitchens. You only need one P-trap to hook up a double sink to a drain, and you route the pipes according to the placement of the wall drain. Disassemble the drain kit it by unscrewing the locknut from the bottom of the strainer.

What is a double bowl sink?

A double-bowl (or divided) sink has two basins in one unit, usually separated by a divider. Traditionally, both sinks would be the same size, and you’d fill one bowl with hot soapy water and the other with clear water for rinsing, however double-bowl sinks are available in a variety of sizes and configurations:…

What is a sink pipe?

A sink pipe is one of the most essential parts of the entire sink assembly. Without the pipe going from the bottom of the sink to the drain, water will simply run out all over the cabinets and floor. When talking about sink pipes there are some basics that you should know about. There are two basic types of pipe that are used in a sink.