Can you put rings in an industrial piercing?

Circular barbells, labret studs, and captive rings all work well in industrial piercing holes if you do not want to wear a standard barbell. There’s also a really neat piece of jewelry called a spiral that can be twisted in and out of both holes to wrap around the top of the ear.

How much is a industrial piercing earring?

Although the industrial piercing consists of two piercings, you’ll usually only be charged for one. It typically costs somewhere around $30 – $70. As always, choose a quality piercer over expense.

Does an industrial piercing hurt?

Industrial piercing is most painful since it involves two parts of cartilage. This makes it much more painful and takes more time to heal. However, it is the most stylish form of ear piercing.

What is another word for industrial piercing?

An industrial piercing (North America), sometimes called a scaffold piercing (UK/Ireland) or construction piercing, is any two pierced holes connected with a single straight piece of jewelry (compare to orbital piercing); however, it typically refers to a double perforation of the upper ear cartilage specifically.

How long till industrial piercing stops hurting?

Pain during the aftercare stage can last throughout the entire healing process. That’s usually 6 to 8 months for this piercing. Although, the worst of the healing pain should resolve in less than a month.

Can you shower with a new industrial piercing?

Showering It’s perfectly safe to continue showering and washing your hair while your piercing heals. You may want to opt for a natural shampoo if the chemicals are irritating the area. Otherwise, simply take extra care to thoroughly rinse the soap and shampoo from in and around the piercing.

Where can I get stainless steel rings made?

Slots and other fabrications can also be done around the circumferal length in the secondary fabricating presses and prenotch presses. Separate special fittings and clasps can also be produced and provided or assembled by Johnson Bros. onto the ends to provide finished Clamp Rings.

Who are the manufacturers of wire snap rings?

Arcon Ring has been supplying various industries with stamped retaining rings, wire snap rings, Eaton type rings, spiral rings, metric circlips, springs and specialty rings for over forty years.

What kind of metal is used to make rings?

Metals used are the same as with all roll formed parts however, very high strength materials are much less desirable in ring forming. Heat-treating Rings after forming will cause diameter distortion.

How big of a part can be rolled into a ring?

This is a completely different, separate manufacturing method called Rolling and is usually only beneficial on small volumes, thick parts over .125″ thick, or parts too thick to be bent into smaller diameters on a roll forming machine. It is also very difficult to bend very wide parts into rings.