What does P1694 code mean?
What does P1694 code mean?
P1694-CCD MESSAGE FROM JTEC FAILURE Possible Causes: INTERMITTENT WIRING AND/OR CONNECTORS. CCD BUS (+) CIRCUIT OPEN TO PCM. CCD BUS (-) CIRCUIT OPEN TO PCM.
What is the code P1495?
Error Code P1495 refers to a problem in the vehicle’s leak detection pump, which is part of the emission system. This code is detected when the PCM (powertrain control module, also known as ECM or engine control module in other vehicle makes) determines that the solenoid did not change status when activated.
How do I fix code P0753?
What Repairs Will Fix P0753?
- Changing the transmission fluid and filter.
- Replace faulty solenoid.
- Repair or replace a faulty transmission pump.
- Repair or replace defective transmission valve body.
- Perform transmission flush to clean passages.
- Cleaning corrosion from connectors.
- Repairing or replacing wiring.
What does the p1494 code on a jeep mean?
P1494 JEEP Meaning The Evaporative emissions system is designed to prevent the escape of fuel vapors from the fuel system. Leaks in the system ca allow vapors to escape into the atmosphere. The leak detection system tests for EVAP system leaks and blockage.
What does trouble code p0700 mean on Jeep Cherokee?
One of the most common problems with the Jeep Cherokee is when it throws the P0700 trouble code. A trouble code is a code thrown out by an automatic transmission whenever it detects in the Cherokee that there is an issue that needs your attention. P0700: Transmission Control System Malfunction In the case of the P0700, it is a general code.
What is code p1494 for leak detection pump?
Nonetheless, as stated before, code P1494 is less concerned with leaks in the EVAP system than it is with whether the Leak Detection Pump is working or not.
What does trouble code mean on Jeep Cherokee?
A trouble code is a code thrown out by an automatic transmission whenever it detects in the Cherokee that there is an issue that needs your attention. In the case of the P0700, it is a general code. This means that it should be accompanied by some other code that should tell you the specific problem.