Tips

How many VLANs can we configure in a switch?

How many VLANs can we configure in a switch?

4096 VLANs
A switch supports a maximum of 4096 VLANs, among which VLANs 0 and 4095 are reserved for system use, and VLAN 1 is the default VLAN. Therefore, you can only create VLANs 2 to 4094. You can repeat the vlan command multiple times.

How can I see the configuration of a Cisco switch?

On Cisco Router/Switches:

  1. Type “terminal length 0” in privileged mode to set your terminal to display without any breaks.
  2. Type “show run” or “show start” to show the applicable config.
  3. To display the config without lengthy certificate data, use “show run brief “.

Do switches have an IP address?

To summarize, unmanaged and layer 2 switches do not have an IP address, whereas managed and layer 3 switches do. Having an IP address assigned to your switch provides you with a way of connecting to it remotely and perform any configuration that is needed.

Do you need to configure a switch?

Most switches used by small businesses and home offices typically require no configuration — they’re “plug and play.” However, it’s important to remember that plug and play doesn’t always work. In addition, these switches certainly don’t offer any troubleshooting, logging, security, or manageability.

How do you set up a Cisco switch?

Configuring a Cisco 3548 switch is very simple. Connect the Cisco 3548 switch’s console port with the computer’s com port by using the UTP roll over cable. After physical connection, make a HyperTerminal session and give it any name. The com port setting should be Restore Default in the com port’s properties.

What is the purpose of a Cisco 2960?

They operate on Cisco IOS ® Software and support simple device management as well as network management. The Cisco Catalyst 2960-X and 2960-XR Series provide easy device onboarding, configuration, monitoring, and troubleshooting.

Does Cisco 2960x support WCCP?

According to the Cisco website, Cisco 2960X WS-C2960X-48TD-L doesn’t support WCCP, but 2960XR with IP base or IP services license does.

What is the default IP address for Cisco switches?

To access the Cisco SG300-28 switch, use the default IP address 192.168.1.254. It needs to be entered into the web browser’s navigation bar where URL’s go.