Tips

How do I reset my HP EVA controller?

by Ellenor Mcfarland

How do I reset my HP EVA controller?

Re: EVA Controller Reboot Instructions In Command View select the EVA – shutdown – restart – Controller A/B. HP support should be able to tell you which one is the master controller.

How do you shutdown HP EVA P6000?

It is recommended to perform this action with P6000 Command View.

  1. Start HP P6000 Command View.
  2. Select the appropriate storage system in the Navigation pane. The Initialized Storage System Properties window for the selected storage system opens.
  3. Click Shut down.
  4. Under System Shutdown click Power Down.

What is EVA controller?

EVA controller resync provides a fast reboot of both controllers simultaneously. This causes both controllers to restart, bypassing execution of MIST diagnostics. This affects the time it takes for the dual controller resynchronization to complete.

How do I turn off HP Storage?

To shut the storage system down, perform the following steps:

  1. Start HP Command View EVA.
  2. Select the appropriate storage system in the Navigation pane.
  3. Click System options.
  4. Click Shut down.
  5. Under System Shutdown click Power Down.
  6. Turn off the power switch on the rear of each HSV controller.

How do you turn off MSA 1050?

To power off the system:

  1. Stop all I/O from hosts to the system.
  2. Shut down both controllers using either method described below:
  3. Disconnect the power cord female plug from the power cord connector on the power supply module.

How do I add a host to my MSA 2040?

Add Host in MSA 2040 SAN

  1. First, find the host’s WWN or IQN.
  2. Login to HPE Storage Management Utility (SMU) by using credentials, default username/password are manage/!
  3. In the Configuration View panel, right-click the system or Hosts and then select Provisioning >> Add Host.

How do I reset my storage controller?

To restart the storage controller using SMU v2:

  1. Select Tools→Shut Down or Restart Controller→Operation: Restart→Controller→Type: Storage→Controller: A|B.
  2. Click Restart now. A confirmation message appears.
  3. Click Yes to continue. A message describes restart activity.

How do I add a host to my MSA 2050?

In the Configuration View panel, right-click the system or Hosts and then select Provisioning >> Add Host. You can also select the same from the right side as shown in the screenshot. In the right-side panel, enter the details as asked in below screenshot. Host ID (WWN/IQN): Enter the host’s WWPN or IQN.

How do you reset a Compellent controller?

How to restart controller

  1. Log in to either the Dell Storage Manager or the Enterprise Manager.
  2. Click Hardware tab, and expand the Controller from the left pane.
  3. Right-click the Upper Controller and click Shutdown/Restart Controller.