How do you fix a VSC on a 2005 Toyota Highlander?

Park the vehicle, turn off the engine and set the parking brake. Open the vehicle’s hood and disconnect the battery’s negative cable for 15 seconds, using an appropriate size socket. Disconnecting the negative battery cable will reset the vehicle’s computer and clear the “VSC” warning. 15 people found this helpful.

What is VSC on 2005 Toyota Highlander?

VSC is short for ‘Vehicle Stability Control,’ which is the stability control system that Toyota uses in their vehicles. Stability control helps your vehicle maintain traction and control by reducing—or completely cutting—power sent to your wheels.

How do you turn off the VSC on a Toyota Highlander?

Simply push and release the VSC Off button located near your gear shift, and your TRAC will be turned off. Look for the TRAC OFF indicator light near your speedometer. Your VSC Off indicator light will be here as well. When you want to turn the TRAC back on, just push the button again.

How does the VSC system on a Toyota Highlander work?

The VSC system works by piggybacking off of the Highlander’s ABS system, which means that if one has a problem, the other one usually does too. The VSC system works by using the wheel speed sensors to detect when one of the wheels is not getting have traction. It then applies the brakes to that specific wheel to keep it from spinning.

Do you need jumper wire for Toyota Highlander VSC light?

This procedure can be performed without special equipment such as a hand-held tester or OBDII reader. You only need the equivalent of a jumper wire to short together two pins of the OBDII connector at the right time and the right number of times between switching the 4Runner on and off.

Is there a problem with my Toyota Highlander?

Your Toyota Highlander will run and drive completely normal. You do need to be aware that the vehicle stability control system is an important safety feature. Ignoring the problem for a prolonged period of time is not advised.

How does VSC work on a Toyota Camry?

The VSC system works by using the wheel speed sensors to detect when one of the wheels is not getting have traction. It then applies the brakes to that specific wheel to keep it from spinning. At the same time, it also reduces engine power.