What do you nail Hardie soffit with?

HardieSoffit® panels must be fastened to a solid, nailable substrate such as a wood 2x subfascia. Additional framing may be needed to ensure proper fastening. Soffits can be installed as shown in figure 1.

Can Hardie panel be used for soffit?

long, ¼ in. thick factory-primed fiber-cement panels designed to be used on the underside of eaves as soffit material. HardieSoffit panels are available as vented or non-vented boards. in of net free ventilation per lineal foot of soffit.

Can you use screws for soffit?

Round head screws designed for installing soffits and gutters. Blends with siding colour.

What is soffit on your house?

The soffit is part of the overhang where your roof meets your siding. When rain or snow hits your roof, it runs down, and the overhang allows the water to flow away from your house. The soffit is underneath the overhang, between the roof’s edge and side of your home—the bottom of the triangle, if you will.

Can you install hardiplank over steel studs?

Hardiplank lap siding can be installed over braced wood or steel studs spaced a maximum of 24” o.c. or directly to minimum 7/16” thick OSB sheathing. Hardiplank lap siding can also be installed over foam insulation up to 1” thick.† Irregularities in framing, sheathing, and/or foam insulation can mirror through the finished application. A weather-

How big of a sheathing do I need for hardiplank?

minimum 7/16” thick OSB sheathing. Hardiplank lap siding can also be installed over foam insulation up to 1” thick.† Irregularities in framing, sheathing, and/or foam insulation can mirror through the finished application. A weather-resistive barrier is required *. Install Hardiplank siding with joints butted in moderate contact.

What do James Hardie soffit panels look like?

House Soffit Panels | HardieSoffit Panels | James Hardie Soffits are key construction elements—they cover the underside of your roof eaves and exterior porch ceilings. Explore our smooth and vented profiles. Customize this Site

Which is the correct way to install a hardiplank?

1) Install 1/4” lath strip to ensure consistent plank angle. 2) Begin first course at end of far left wall and nail to stud. 3) Second course begins at the next stud (16” or 24”) to the right